7
SECTION 3. EQUIPMENT SETUP
BATTERY CHARGER
NOTE:
Set up the battery charger and charge all beltpac and/or all-in-one headset batteries while
you are setting up the base station .
Power Supply
Power Supply Cord
1
Connect power supply to charger and electrical outlet .
2
Charge all beltpac batteries . Charging time is approximately three hours .
Put up to 4 batteries in charging ports
Put up to 4 batteries in
charging ports
Storage ports for
charged batteries
Status lights next to each charging port
Red light
• Stays on steady while battery is charging
Green light
• Goes on when battery is fully charged
Yellow light
• Stays on steady when charging port is empty
• Flashes if battery is too hot to charge
• Next to battery in charging port means charge has
failed – see instructions on side of charger
Red light
• When you place a battery in a port for charging, its
status light will turn red .
Green light
• When a battery is fully charged, its status light is green .
Yellow light
• When a battery charging port is empty, its status light
is yellow .
Storage ports for charged batteries
Plug the cord from the +5VDC power
adapter into the battery charger, and
then plug the power adapter into an
electrical outlet .
AC50 US and international
power supplies and adapters
