VIITS-SS001
-
9
-
2. Installing the Front Suspensions
NOTICE
Refer to the service manual for torque specs when tightening bolts and nuts. Make sure to tighten the bolts
and/or nuts to the specified torque to avoid the damage to the bolts, nuts and/or shock absorber internals.
CAUTION
After re
-
mounting the tires, make sure the product does not
come into contact with the wheels/tires.
Re
-
alignment is required after installation of this product.
2
-
2
M8(
φ
15.5) Washer ,
Nut
⑧
2
-
3
⑦
2
-
4
⑥
⑤
2
-
1
M10 Flange
Nut
⑩
Stabilizer
Link
1. Hold the lower arm with a jack using a wooden block.
Install the provided front suspension assy to the vehicle using the
bolts and nuts for the lower front suspension assy
⑩
.
(Torque Specs: 75N·m)
(Diagram 2
-
1)
2. Install the provided stabilizer link using the provided M10 nuts.
(Torque Specs: 60N·m)
(Diagram 2
-
1)
3. Install the following:
The nut for the upper front suspension assy
⑧
.
The provided M8(
φ15.5
) washers.
(Torque Specs: 20N·m)
(Diagram 2
-
2)
4. Install the height sensor installation bolt
⑦
.
(Torque Specs: 5N·m)
(Diagram 2
-
3)
5. Install the following:
The brake line
⑥
The speed sensor harness
⑤
.
(Diagram 2
-
4)
6. Remove the jack from the lower arm.
Mount the wheels back on, then lower the vehicle.
7. Install the following:
The cowl top
③
The wiper
②
The cowl top cover
①
.
(Diagram 1
-
1)
*If the area around the mounting hole is covered with sealing
material, remove the sealing material from the washer mounting
area and adjust the washer to a position where it will fit better.