80250-AT005
-
7
-
1. Removing the Factory Front Suspensions
WARNING
When installing this product, do not use scissor
-
jacks supplied with the vehicle. Use of unstable scissor
-
jacks
can lead to severe bodily injury or death. Always use vehicle lifts/hoists or garage jacks with jack
-
stands.
CAUTION
· Perform installation after the vehicle has cooled down sufficiently.
· For height adjustments, only adjust height within the range specified in this manual.
If adjusted above or below the specified range, the suspension and/or vehicle may become damaged.
· If there is too much play in the springs, the springs may fall off of the spring seats and cause damage to the
suspensions and/or vehicle.
1
-
3
⑥
1. Jack up the vehicle, and remove wheels.
2. Remove the following:
The stabilizer nuts
①
The factory stabilizer link
②
.
(Diagram 1
-
1)
*The removed nuts
①
and factory stabilizer link
②
are not reused
to install this product.
3. Hold the lower arm with a jack using a wooden block , and remove
the following:
The brake line and the ABS sensor harness installation bolt
③
The ABS sensor harness installation clip
④
The bolts and nuts from the lower front suspension assy
⑤
.
(Diagram 1
-
2)
4. Remove the front suspension support dust cover
⑥
.
(Diagram 1
-
3)
*The removed cover
⑥
are not reused to install this product.
③
1
-
2
⑤
④
1
-
1
②
①