47
48
Main Camera
1.3M Pixel CMOS Digital Sensor 142.5
°
Record
1.3Mega (Input 1280x960, Output 640x480)
Resolution
or VGA (Input 640x480, Output 640x480)
Number of Frame
1 Channel - 1.3Mega: 15 fps / VGA: 30fps
2 Channel - 1.3Mega: 8fps / VGA: 15fps
Video Compression H.264
Constant Recording Mode: Constantly records in 3 minute segments
Recording Time
Shock Sensing Mode: Records 15 seconds before and after an event (total 30 seconds)
The provided 8GB SDHC memory card allows for 16hours 1ch recording.
Impact Sensor
Built-in 3 axes Gravity Sensor
GPS
Built-in GPS
Storage Media
SD/SDHC memory card (2GB ~ 16GB)
Sound
Built-in Microphone
Buzzer
Set to sound at initialization, firmware update, events, turning the power-off.
LED
3 LED (Initialization, Recording, GPS Signal Reception, Microphone On/Off)
Image Viewer
Viewer Software provided. Recorded images can be played by standard media players.
Size
H
:
107mm / W
:
60mm / T
:
19mm (Attachment not included.)
Weight
90g (Attachment not included.)
Power Source
DC12V ~ 24V Negative Ground
Main Material
PC
、
ABS
Operating Temperature -10
℃〜
60
℃
Second Camera
0.27M Pixel Color CCD Sensor 130
°
(monochrome at dark places)
Power Source
DC12V Negative Ground
Operating Temperature
-10
℃〜
60
℃
Power Source
Input: DC12V ~ 24V Negative Ground
Output: DC12V
Main Material
PC
Operating Temperature
-10
℃〜
60
℃
Second Camera
DMR Main Unit
Constant Power Supply Unit
If this product does not perform properly, check the following items.
If any further assistance is required, please contact your dealer.
◆
The unit does not power on.
○
If the LED (Red/Purple
・
Blue) do not come on after power is on, make sure the Power Cable is con-
nected properly. Contact your dealer if LED still do not come on even the Power Cable is properly
connected; the SD memory card may be damaged.
○
If the LED (Red/Purple
・
Blue) comes on dimly, and the DMR does not work, disconnect the power
cable from the DMR main unit, and reconnect the cable after leaving the cable disconnected for 30
minutes.
○
12.3V (24.5V) or higher voltage must be applied to operate the Constant Power Supply Unit.
Check the battery voltage.
◆
The DMR does not detect the SD memory card.
○
Turn the power off and eject the SD memory card. Make sure any foreign objects are adhered to
the terminal. Make sure the SD memory card is not write-protected.
Also,
・
It takes longer to start activating the unit after power is turned on.
・
The unit does not beep at all or beep less than 3 times when deactivating the unit (when warning
・
beeping sound is on.).
・
The DMR viewer software is shut down when viewing a file or a message "File is broken" appears
・
when trying to view a file from the SD memory card on a PC.
When any symptom described above is noticed, format a SD memory card.
Symptoms may be improved.
◆
The GPS signal cannot be received.
○
Reception of the GPS signal may be very poor depending on the area and/or place.
Move the vehicle to the open place, and wait for a few minutes until reception is recovered.
◆
The Viewer Software does not show any map.
○
Make sure the internet connection is setup properly. Also, make sure Internet Explorer is the
version 7.0 or later.
49
50