occasionally necessity to change this parameter may arise. Follow the recommendations
concerning boiler temperature range and the controller's manual.
•
Set the central heating temperature, tap water temperature, the heating profile and the
night cool-down for a weekly cycle. Initial parameters shall be set by the service. Read the
controller's manual thoroughly before attempting any alterations. Remember that it may take
a few hours before response of the system to setup change is perceived.
•
You can also set up the parameters of the mixing valve should you install one. Initial
parameters shall be set by the service. Always record the current setup before attempting any
adjustments so you can restore it should the alterations prove unwelcome.
•
Clean the heat exchange regularly using the knob of the manual cleaning system.
•
The burner is cleared automatically following the intervals in the setup measured by
operation hours.
All hatches and inspection doors must be shut when the boiler is working!
7.3. Maintenance and cleaning
Within the cleaning routine during operation you should:
•
Replenishment fuel in the container regularly;
•
Clear ash off the ash tray - check amount of ash once a week.
•
Remove ash from the combustion chamber;
•
Clean the heat exchange using the manual cleaning system.
Amount of ash deposit depends on the fuel used and amount of fuel burned. Except of ash, trace
amounts of creosote are deposited. Unscrew the two butterfly nuts at the sides of the ash tray door
when you want to remove ash. You need simply to pull the ash tray off the chamber.
Ash in the combustion chamber falls down from the heat exchange when it is being cleaned.
Access the combustion chamber unscrewing two handles holding the inspection door. Sweep the
ash to the ash tray.
Clean the heat exchange regularly using the manual cleaning system. Its enough to make a few
Instrukcja Smart Fire
wer. 07/05/2010/ENG
HKS LAZAR
str.14
