Force gauge Hand Terminal HT 6.0
6
Operation
4. Operation
4.1. Switching on:
By pressing the button, the force gauge is switched on.
The nominal load of the transducer is shown briefly on the display. Always make sure that this load is not exceeded.
The current measured value is shown in the display.
Please note that a previously tared value has been retained. The peak values were deleted.
4.2. Using the menu: MENU
The menu provides the following options:
- Read out information about the device -> “About” menu option
- Configure device settings -> “Configuration” menu option
- Calibrate the device -> “Service” menu option (this area is password-protected and can only be configured by the factory).
Enter
Enter
Enter
Enter
Enter
Esc
Esc
Esc
Esc
Esc
Measuring
mode
HKM-Messtechnik GmbH
www.hkm-messtechnik.com
Operating Instructions Force gauge
Status 03.2011
