7-2-2. ADJUST
When performing the automatic mechanical iris adjustments, the convergence speed which is
suitable for the lens installed is calculated, Shoot a high-brightness subject which will make the
brightness of the whole screen uniform.
-Check that the shooting conditions are sufficiently bright and stable.
7-2-3. SPEED
Sets the convergence speed.
7-3. FLIP
Select digital Flip / Rotate state
Off / V(Top / bottom reversal) / H(Left / right reversal) / HV(Rotation by 180 degrees)
7-4. LCD / CRT
Seclect Monitor mode.
7-5. COMMUNICATION (OPTION)
Communication using the RS-485 format.(Option)
Press the Enter button to access the Communication.
Protocol
- RS-485 protocol. (PELCO-D)
ADDRESS
- Select the camera ID. (001 - 255)
Baud Rate
- Select serial communication speed. (2400 / 4800 / 9600 / 19200)
Note.
Key of Keyboard Controller
MENU
Joystick Handle turn clockwise , ZOOM TELE
ENTER
Joystick Handle turn clockwise, IRIS CLOSE
OSD Cursor Movement
Joystick Up / Down / Left / Right
7-6. CAMERA ID
CAMERA ID SETUP.
SAVE
Save the settings (settings are saved)
NOT SAVE
Exit
Menu without saving SAVE : Exit menu without saving.
CANCEL
Changes (restore settings to those selected when the menu was displayed)
BACK
Return to previous menu
RETURN
Return to page on the hierarchical level immediately before.
8. EXIT-MENU
CAMERA ID
CAMERA ID
ABCDEFGHIJKLMNOPQRSTUVWXYZ
0123456789`~!@#$%^&*()-_=+<,>.?/;:’”
CLR POS
RETURN
CLR
Inserts a space
POS
Allows you adjust the location of the camera ID title display. (if you move too
much right side or down, it might lose ID on the screen)
Sets the camera ID to ON or OFF. A title of 64
Characters per line can be applied.
Use the joystick to navigate the cursor.
Pushing centrally on the joystick will allow selection
of that character.
The arrows at the bottom allow you to move the
cursor without changing the character.
13