Operation—Operating The Machine
TX14740,0001FB6
–19–09JAN03–2/2
Port designations (letters) are on the pilot signal
manifold next to the ports.
CAUTION: Prevent injury from unexpected
control lever function. Install new labels on
control consoles.
6. When changing to the backhoe control lever
pattern, remove the old labels and install the
black-on-yellow labels on the left and right control
consoles near base of control levers. Labels are
enclosed in Operator Manual package.
When changing to the excavator control lever
pattern, remove the old labels and install the
black-on-white labels on the left and right control
consoles.
Additional labels can be purchased from your
authorized dealer.
7. Tighten hydraulic vent plug.
A control pattern selector kit is available through
service parts. When installed, it changes the
control lever pattern using a solenoid valve.
OUT1739,00001F6
–19–16JUN06–1/1
Operating in Water and Mud
T136459
–UN–18DEC00
1—Drain Plug
Be careful not to operate the machine in water or mud
above the upper deck surface of the undercarriage,
causing the swing bearing and rotary manifold to be
submerged.
If the swing bearing and rotary manifold are submerged,
remove cover from underneath center of machine.
Remove drain plug (1) to drain water and mud.
Clean swing gear area. Install plug and cover. Grease
swing gear and swing bearing. (See Grease Swing
Bearing Gear and Grease Swing Bearing in section 3-7.)
2-2-16
081407
PN=69