Hitachi W 4YD, Technical Data And Service Manual

Page: 13 / 23

--- 10 ---
(b) Each component of the socket ass'y can be removed by removing the Retaining Ring [29] (Fig. 4). Be careful
not to lose the Steel Ball D3.175 [34] .
* Be careful of the mounting direction of the Retainer [30] , Guide Sleeve (A) [32] , Metal [33] and Clutch Disc
[36] at reassembly.
Hold the body and adjust the gap of the retaining ring to the
groove of the Socket [35] , then insert a small flat-blade
screwdriver into the groove at an angle.
Press down the Retainer [30] and with the small flat-
blade screwdriver.
Fig. 4-2
Fig. 4-1
1 2
Small flat-blade screwdriver
Socket [35]
Retaining Ring [29]
Retainer [30]
Gap of retaining ring
Guide Sleeve (A) [32]
Slide the small flat-blade screwdriver under one side
of the gap of the retaining ring.
Slowly raise the Retaining Ring [29] using the end face
of Guide Sleeve (A) [32] as a fulcrum.
Fig. 4-4
Fig. 4-3
3 4
Then slowly raise the other side of the retaining ring with the small flat-blade screwdriver until it is free. Avoid
quickly raising the retaining ring or it may fly out forcefully.