9-5
●
On-screen message descriptions
(2) Faults that do not invoke ink stoppage
No.
Message
Meaning of message
Remedy
42
Ink Drop Charge
Too High
The value of the signal that detects the ink
drop charge is too high.
●
Clean the gutter, deflection
electrode, and its
surroundings.
●
Adjust the excitation V-ref. to
make sure that the ink drops
are well made.
( Technical manual 6.10)
●
Adjust the ink pressure.
●
Check that the ink stream is
correctly retracted.
( Technical manual 6.9)
43
Barcode Short On
Numbers
The number of characters for the selected
barcode type (EAN-13, EAN-8, UPC-A,
UPC-E) is insufficient.
●
Configure the number of
characters for barcode to
appropriate value.
44 Shutdown Fault
Power cutoff procedure failed.
●
Execute power cutoff again.
45 Count Overflow
The count value is multiplied by count
multiplier, and the number of digits of the
integer part of the result exceeds the
number of digits of the input count
characters.
●
Reconfigure the count
conditions.
49 Print Overlap Fault
The next print start signal entered before
the current printing operation was
completed.
●
If the printing frequency is
high, lower it.
●
If the print start signal
chatters, perform sensor filter
setup.
( 4.13.1).
50
Print Head Cover
Open
The print head cover is open.
●
Remove the cover and then
hit the Clear key.
●
If a magnetic substance is
used to fix the cover,
it must be replaced with
nonmagnetic resin (metal).
51
Improper Sensor
Position
While the "signal ON period" mode was
selected for continuous printing, the print
start signal turned OFF before anything
was printed.
●
Shift the sensor closer to the
nozzle head.
●
If the print start signal
chatters, eliminate its cause.
52 Target Sensor Fault
The duration of sensor light blockage
exceeded the "target sensor timer" setting.
●
If the print target is stopped
with the sensor ON, remove
the print target.
●
Review the target sensor
timer setting.
( 4.13.1).
53
Target Spacing Too
Close
Five or more print targets were placed
between the sensor and nozzle head in the
noncontinuous print mode.
●
Position the sensor closer to
the nozzle head so that no
more than four print targets
can enter between the sensor
and nozzle head.
Summary of Contents for RX
Page 188: ...2 J0808 2C ...
