Hitachi RX, Instruction Manual

Page: 14 / 188

● Shutdown 1-3
M
Manual
2015.07.07 12:45
M
Manual
Startup
Com=0
＝＝＝＝＝ Manual Control Menu ＝＝＝＝＝
Start
printing
The current message is
printed.
No-cleaning
stop
Stops ink ejection
without cleaning.
Cancel
Standby
No deflection voltage is
applied. The printer
status becomes Standby.
＝＝＝＝＝
Shutdown Process Confirmation
＝＝＝＝＝
Shutdown will stop the ink jet.
Solution To stop the ink jet, press <OK>.
OK
Close
1.4 Shutdown (no-cleaning stop)
When you press the Shutdown on the upper right-hand corner of the screen, the printer stops after
completing its automatic nozzle cleaning sequence. If you repeatedly activate the Shutdown to stop an
operation, excessive makeup will enter the printer, thereby thinning the ink or producing an unduly high ink main
tank solution level. If it is absolutely necessary to repeatedly stop the printer operation, use the following
procedure.
Press the Manual .
(The Manual is displayed commonly on all the screens.)
Press the No-cleaning stop within the control menu.
Press the OK .
An ink stop confirmation message appears.
*1: Do not use the Shutdown to stop operation more than two successive times.
*2: When operation was stopped using No-cleaning stop , if left in that state, the ink will become stuck in the
nozzle and cause ink stream bending, nozzle clogging, and printing disturbance. Apply makeup to the
orifice plate to wash it within 30 minutes after a stop to cause the ink to eject once again.
1
2
The no-cleaning stop procedure works even while the startup sequence is
being executed.
(The Shutdown button is inoperative during the startup sequence.)
Shutdown
Shutdown
M
Manual
2
3
Manual
Common to all screens
No-cleaning stop