Hitachi RM-LTX7000, Instructions Manual

Page: 9 / 29

-4-
Catch
Attachment/detachment button
Fan
(Built-in)
Charger socket
Insert the plug for equipment of the power
adaptor.
Power adaptor : KH-187B
Power plug
Insert this into the outlet to its base.
Plug for equipment Cord
Cleaning brush
Shaver oil
Pouch
Charging completion lamp
“ ”
During charge: The lamp turns on. (Red)
After charging is completed: The lamp
turns off.
Main body
Center trimmer
Swivels to securely catch beard.
Trimming blade
Used when a difficult to shave long beard
is shaved with the foil, or when
sideburns are closely trimmed.
Mode indicator (Blue)
Auto (flashing) Power (lighting),
Normal (lighting off)
Auto lamp (Green)
The auto mode operates to light
the lamp.
Remaining battery level indicator lamp
The capacity of the battery is displayed
by three lamps. When the "EMP" lamp
flashes during use, this indicates that
charging is required.
Trimming knob : Slide this upward.
Comb
Guides long or rough beard into the foil.
LED light dryer
(Included in the RM-LTX7000DY)
Charging connector
Main body detection switch
The dry switch cannot be turned on unless
the main body is set properly.
Light emitting lens
Dry switch
Each time the switch is pressed, it switches
between ON and OFF.
Lights during drying.
Flashes slowly (at intervals of 2 seconds)
while the cutter is made to be
antibacterial.
Flashes quickly (at intervals of 0.5 seconds)
to indicate an error.
Preparation before use
How to charge
Charge before first use.
Make sure to use the included power adaptor for 100 - 240V AC power.
You can also charge by using an LED light dryer.
The recommended charging temperature is in the range of 10 – 35°C
At a temperature below the recommended temperature, the charging response may slow down,
causing an insufficient charge and a reduced number of operating times.
Each battery has a service life.
(The battery life greatly varies according to the conditions of use and storage.)
If the number of operating times is extremely small in spite of use in accordance with the
instructions, it is considered that the battery life is about to expire. For battery replacement, consult
with your distributor or customer service representative listed.
Never connect or disconnect to/from the outlet with wet hands. (Cause of electric shocks or injury)
Avoid using in a place where water is splashed such as a bathroom or in a place with high moisture.
(Cause of electric shocks or short circuits)
Wipe away water drops on the main body sufficiently to dry it before charging.
(Cause of burns due to short circuits and heat generation)
1. Turn "OFF" the switch and connect the power adaptor to the main body and outlet. (Fig.2)
Charging completion lamp
During charge: The lamp lights (red).
After charging is completed: The lamp turns off.
Turn “OFF” the switch. Connect by aligning the (+) and (-) marks on the reverse side.