Hitachi RM-LTX7000, Instructions Manual

Page: 12 / 29

-7-
Power mode
Beard can be shaved strongly and quickly at the time of start or in response to a thick beard. (Fig.11)
The auto lamp is "turned off."
The mode indicator "lights (blue)."
Normal Mode
Beard can be shaved comfortably and softly in response to normal beard and finishing. (Fig.12)
The auto lamp and mode indicator are turned off.
When the switch is turned "OFF," the last mode is stored.
The stored mode is automatically set for the next use.
4. Apply lubricant and store it in a place free from moisture after shaving.
Leaving it in a bathroom, etc., may result in damage since condensation and rust
will occur inside the main body.
Foam-shaving is possible.
Foam-shaving is not allowed with AC. (Cause of short circuits)
Never press it strongly to the skin.
(Cause of damage to skin especially lips and cause of damage to the foil)
Commercially available shaving foam enables to smooth the skin and shave deeper.
Caution
Never use cream and gel shaving agents. (Cause of clogging or damage of the blade)
1. Foam well and apply to the face.
2. Further lightly press it to the skin to shave upward than when shaving dry (without shaving foam).
(Fig.13)
If shaving foam dries during shaving, resulting in poor sliding on skin, apply shaving foam again.
3. Be sure to clean with water after foam-shaving with soap.
For how to clean with water, refer to "Maintenance" .
If soap remains, it will harden and damage the shaver including impairing the rotation of the
cutter, resulting in deterioration in sharpness and a reduction in operating times.
How to use with AC
Avoid using in a place where water is splashed such as a bathroom or in a place with high moisture.
(Cause of electric shocks and short circuits)
Never foam-shave or clean with water. (Cause of electric shocks and short circuits)
1. Connect the power adaptor to the main body and outlet and turn "ON" the switch.
If the battery is completely discharged, the shaver will sometimes be difficult to start.
In this case, if the switch is turned "OFF," the battery is placed into a charging status.
Operate after charging the battery for about one minute.
If the battery is completely discharged, it may take 5 minutes or more to charge it.
How to shave with trimming blade
1. Turn "ON" the switch and extend the trimming blade. (Fig.14)
Use it with the cap. (Otherwise, hair may enter the blade.)
2. Lightly press the trimming blade perpendicular to skin and slowly shave in the arrow direction.(Fig.15)
Never press the blade edge strongly. (Cause of damage to skin)
If hair has intruded the blade edge at one time, hair is pulled and entanglement is
caused, and it may result in deterioration in sharpness.
2. Use following “How to shave with the foil.”
3. After use, turn "OFF" the switch and disconnect the power adaptor from the outlet and main body.
Recommended
The battery is also consumed when the shaver is used with A/C. Charge it once a month.
Auto lamp “turns off.”
Mode indicator “lights.”
Auto lamp “turns off.” Mode indicator “turns off.”
With the cap attached
Place your thumb on the projection of the trimming knob, and push it up.