– 14 –
MAINTENANCE
Before the cleaning, stop operation and disconnect the power supply.
1. AIR FILTER
Clean the air filter, as it removes dust inside the room. In case the air filter is full of dust, the air
flow will decrease and the cooling capacity will be reduced. Further, noise may occur. Be sure to
clean the filter following the procedure below.
2. CLEANING OF FRONT COVER, ETC.
●
Never use hot water (above 40
°
C),
benzine, gasoline, acid, thinner or
a brush, because they will damage
the plastic surface and the coating.
CAUTION
●
Wipe it with a soft dry cloth.
●
When it is excessively dirty, wipe
with a soft cloth soaked in
lukewarm water or neutral
detergent. Then wipe thoroughly
with a soft dry cloth.
●
Wipe the remote controller
thoroughly with a soft dry cloth.
Set the filter with “FRONT” mark
facing front, and slot in them to the
original state.
●
Do not wash with hot water at more than 40
°
C.
The filter may shrink.
●
When washing it, shake off moisture completely
and dry it in the shade; do not expose it directly
to the sun. The filter may shrink.
●
Do not operate the air conditioner with the filter
removed. Dust may enter the air conditioner and
cause trouble.
1. Remove dust from the filter using a vacuum
cleaner.
If there is too much dust, use neutral detergent.
After using neutral detergent, wash with clean
water and dry in the shade.
2. Install the filters.
(Set them with “FRONT”
mark facing front.)
Slot in the filter to the original state.
METHOD REMOVE
1. Press the “ (AUTO SWING)”
button, let the deflector facing
downward.
2. Remove the filter from the lower side
as shown by the arrow.
METHOD INSTALL
CAUTION
BENZINE
A
C
I
D
THINNER
!
PROCEDURE
CAUTION
!
!