–
8
–
NAMES AND FUNCTIONS OF REMOTE CONTROL
FUNCTION Selector
Use this button to select the operating mode. Every
time you press this button, the mode will change from
AUTO
→
COOL
→
DEHUMIDIFY
→
CIRCULATION
→
FAN cyclically.
AIR PURIFIER Button
Press this button to start the air purifier mode.
TWIN AIR FLOW Button
Use this button to allow two different air flows circulate
in every corner of room efficiently.
PARALLEL WING Button
Use this button to control angle of the vertical air
deflector to parallel.
AUTO SWING Button
Controls the angle of the horizontal air defelctor.
FILTER Button
Press this button when you have cleaned the filter.
About 100 hour after this, the FILTER lamp will light to
indicate that it is the time to clean the filter.
TIMER Control
Use these buttons to set the timer.
RESERVE Button
Time setting reservation.
CANCEL Button
Cancel time reservation.
TIME Button
Use this button to set and check the time.
RESET Button
Press this button after the batteries are replaced or
when some irregular operation is found.
OFF-TIMER Button
Select the turn OFF time.
ON-TIMER Button
Select the turn ON time.
• Do not put the remote controller in the following places.
• Under direct sunlight.
• In the vicinity of a heater.
• Handle the remote controller carefully. Do not drop it on the floor, and protect it from water.
• Once the outdoor unit stops, it will not restart for about 3 minutes (unless you turn the power
switch off and on or unplug the power cord and plug it in again). This is to protect the device and
does not indicate a failure.
• If you press the FUNCTION selector button during operation, the device may stop for about 3
minutes for protection.
Precautions for Use
RAS13EX9G_EN(1-10).p65
3/8/07, 2:42 PM
8
