Hitachi R-HV480NH, Instruction Manual

Page: 44 / 76

44
2
1
1
3
4
2
●
●
BEFORE USE
Preparation before use.
The floor should be sturdy and flat.
Lay a board with 1cm thickness on the floor if the refrigerator is installed on the
carpet, tatami mat, flooring or PVC sheet flooring which may be hollow or discolor.
Place the refrigerator away from direct sunlight and heat.
This will reduce adverse effects to refrigerating power and keep electricity cost down.
Do not place it in damp areas, and ensure good air ventilation.
This will prevent rust and condensation.
The refrigerator should be separated from other equipment such as TVs.
This is to prevent disturbance (noise / scattered image) to TVs and other
devices caused by the refrigerator.
●
●
●
●
※
The actual size of the center part of the side of the
refrigerator's main body is slightly larger than the nominal size.
Therefore, please allow sufficient space around
the refrigerator when installing it.
※
If you are concerned about noise caused by vibration or condensation
on the rear of the refrigerator or discoloration/marking on the
wall due to high humidity, install the refrigerator with a gap of
2 cm or more .
Left and right 0.5 cm or more Left and right 0.5 cm or more
Above 5 cm or more Above 5 cm or more
Adjust and fix the refrigerator horizontally.
To remove leg cover, hold both ends of it and pull it towards
you by applying some force.
Leg cover
Cushion (accessory)
Place cushions under the adjustable mounts.
Place the cushions under the adjustable mounts evenly at the front, back, left and right.
Adjustable mount
●
Always wipe the adjustable mounts and clean the floor before placing the cushions.
Any dirt under the cushions may scratch the floor.
As a guide, the height of the door can be adjusted 1mm every one turn of the adjustable mount.
Insert the supplied tool according to the shape of the adjustable mount.
Turn the left and right adjustable mounts until they touch the floor.
Adjust so that the left and right doors of the refrigerator compartment are parallel.
■
The left side door is lower
Turn the left adjustable mount clockwise
to level the left and right doors
■
The right side door is lower
Turn the right adjustable mount clockwise
to level the left and right doors
Supplied tool (accessory) Supplied tool (accessory)
●
Be careful not to scratch the floor with the supplied tool when turning the adjustable mount.
●
Excessively turning an adjustable mount may cause it to detach.
Insert the fork of the leg cover into the mounting holes to attach the cover.
Fork
Leg cover
Mounting holes
Fork
Cushion
Use the supplied tool and cushion
[2 pc]
Supplied tool
Note
●
Depending on the strength and type of the
floor material, and the weight of the food,
the door may lower several days later
(about 5 days). In this case, adjust the
doors to be parallel again.
●
If the place where the refrigerator is installed
is not horizontal or the floor material is soft,
there may be a height difference between
the left and right doors of the refrigerator.
This will not affect the performance of the
refrigerator. However if you would like to
level it, adjust the doors to be parallel by
following the procedure on the left.
●
Correcting any left / right lean and lifting
slightly the front side of the refrigerator
until the door can be closed easily and
completely.
●
When you release your hand from a
refrigerator door with the door open,
the door may move. But this is normal.