Hitachi R-HV480NH, Instruction Manual

Page: 63 / 76

63
■
Control Panel
3
2
The three indicators "Quick", "On", and "Off" blink at the same time, and "Ice Maker Cleaning" starts.
(About 4 minutes)
1
Remove the Ice Case, wipe off the water inside, and then place it into the Ice Compartment.
Blinking
Ice maker cleaning
When using the automatic ice maker for the first time When it has not been used for a week or longer
Do not touch the mechanical part of the automatic ice maker.
(Doing so may cause injury.)
×
WARNING
Water Supply Tank
・
There is water up to the container full line.
・
It is positioned correctly past the
container set position.
Preparation
Before activating the "Ice Maker Cleaning", please check the following.
Rinse the ice tray and water channel.
Ice case
・
If there is any ice in the ice case,
remove it.
Press and hold for 5 seconds or longer until the alarm sounds.
After checking the items on the left, close all the doors other than the Refrigerator Compartment door
and do the following.
・
Close the Refrigerator Compartment door.
・
The lamp blinks for about 4 minutes and the alarm continues to sound.
・
You cannot cancel "Ice maker cleaning" partway through.
・
If you open one of the refrigerator doors during "Ice maker cleaning", it may not work properly.
Do not open or close any of the doors until "Ice maker cleaning" is finished.
・
The alarm will be activated even if the door alarm is set to "Off". Pg.59
Press and hold
for 5 seconds
Place a water-absorbing towel on the bottom of the Ice Case to prevent water
collected during the ice maker cleaning process from spilling out of the cutout.
When the alarm stops, lay a clean towel on the bottom of the Ice Case to block the cutout
at the rear.
Cutout Towel
Remove the towel you used to wipe off water.
You may continue to use the remaining water in the Water Supply Tank.
After "Ice Maker Cleaning" is complete, the refrigerator resumes back to "On".
MAINTENANCE