31
ENGLISH
OPERATING INSTRUCTIONS (continued)
PinP button
D / N
A /
B
i +
MENU
OK
FREEZE
ZOOM
2-4-12
I / II
P+
P-
+
-
D V D
1
2
3
4
5
6
7
8
0
9
RECALL button
The input signal status can be displayed on the screen
by pressing the RECALL button of the remote control.
• The display will go out in approximately 6 seconds.
AV1
Composite
-- -- Min.
-- -- : -- --
OFF
ON
Input Signal Screen Display
Input mode
Signal mode
Off-timer
On-timer
VIDEO
Displaying MULTI PICTURE
If the PinP button on the remote control is pressed MULTI
PICTURE will display.
Activating the P-in-P mode from the RGB input screen
Pressing the PinP button one time will display 2 pictures.
• This mode can be available from RGB1(DVI-PC) and RGB2(RGB)
input.
• The speaker icon can be shifted up and down by pressing the A/B
button; the audio of the video will be output from the side on which
the speaker icon is located.
• The sub-screen position can be
selected up and down by pressing
SELECT buttons.
• The sub-screen can be selected with
the AV1, AV2, AV3, AV4, and TV
channel number buttons from the
status that the speaker icon appears
on the left side of AV
✱
as shown in
the diagram to the right.
• Pressing the PinP button again or the RETURN button will cancel
the 2 pictures display.
• "Frequency Mode" in the Setup Menu should be set to Movie when
sub-screen is the component signal of 1080i/50 or 1080i/60.
AV1: Displays the VIDEO input signal of the sub-screen.
Activating the Split mode from the video input screen
Pressing the PinP button one
time will display 2 pictures.
• The speaker icon can be shifted left
and right by pressing the A/B
button; the audio of the video will be
output from the side on which the
speaker icon is located.
• The same video input mode cannot
be selected for both screens at the same time.
• Pressing the PinP button again or the RETURN button will cancel
the 2 pictures display.
• When the Video input is set to RGB Video, this Split mode is not possible.
• Refer to the table for 2 pictures (Split) mode.
RGB2
AV1
(Sub-
screen)
AV1
AV2
2 Pictures (Split)
Main
Sub
NOTE
• Even if the input of the horizontal / vertical synchronizing signal (or video signal) stops in the MULTI PICTURE display, the mode will not
change to power save mode.
• Please be careful since image retention will occur if display is left in a MULTI PICTURE display state for a long period of time.
Input terminal
AV1~AV4
AV1, AV2
RGB1
RGB2
PAL
SECAM
NTSC3.58
NTSC4.43
576i
576p
480i
480p
1080i/50 1080i/60 720p/60
STB
Component
AV1
~AV4
PAL, SECAM
NTSC3.58/4.43
AV1
AV2
576i, 576p
480i, 480p
1080i/50
1080i/60
720p/60
RGB1
STB
RGB2
Component
(
: Available)
Main
Sub
A/B button
SELECT button
