— 12 —
English
(2) Insert nail strips one by one from above the magazine.
Two strips can be loaded at one time.
(3) Press the stop lever and slide the nail feeder forward
until it contacts the nail strip.
NOTE:
Use nail strip at least 5 nails remaining.
Set heads of nails overlapped as shown in the below
figure.
Ensure that the head of tail nail is set under the nail
stopper of nail feeder.
The Nailer is now ready to operate.
NAILER OPERATION
Read section titled “SAFETY”(pages 4 – 6).
DANGER
Always wear eye protector which conforms to
ANSI Z87.1 specifications.
WARNING
Never point Nailer toward yourself or anyone else.
Never carry with finger on trigger.
Remove finger from trigger when not driving nails.
Never place your hands or feet closer than 8 inches
(200 mm) from firing head when using.
Do not drive nails on top of other nails or with
Nailer at too steep of an angle; nails can ricochet
and hurt someone.
In order to avoid double fire or unwanted ejection
of a nail due to bouncing of the Nailer.
1) do not push Nailer on workpiece with strong
force;
2) take Nailer away from workpiece using recoil;
3) release trigger quickly when performing trigger
fire.
Do not drive nails into thin boards or near corners
and edges of workpiece. Nails can be driven
through or away from workpiece and hit someone.
Never drive nails from both sides of a wall at the
same time. Nails can be driven into and through
the wall and hit a person on the opposite side.
Never use Nailer which is defective or operating
abnormally.
Do not use Nailer as hammer.
Nail Strip
Magazine
Nail Feeder
Stop Lever
Tail Nail
Nail Stopper
Summary of Contents for NR 90AA
Page 46: ... 46 Español ...