Hitachi LP-WU9750B, User Manual

Page: 46 / 90

46
OSD Menu description
Over Scan
Due to the fact that some consumers may still be using older television systems, some TV programs
may not display the edges of the picture. Use this function to hide the picture edge by choosing one of
the following three options:
•
Off
Setting it to off makes no change to the projected picture.
Note: When Over scan set to Off. Aspect Ratio can't adjust.
•
Crop
Setting it to "Crop" will add two "masks" equivalent to 3% of horizontal resolution on either side of
the picture and two similar masks above and below the projected picture.
•
Zoom
You can use this function to enlarge the picture's horizontal resolution over the 106% of the default
aspect ratio. Any portion that exceeds the original picture will be cropped.
16:10
Off Crop Zoom
4:3
Position and Phase
•
V Position
Use ◄► to adjust the projected picture’s vertical position.
If the projected picture is not at the center of the screen (i.e. shifted up or down) and ends
up being cropped, use this function to adjust the picture’s vertical position. The following
picture is an example of test picture from an external signal source:
Native picture Skewed
Down Up
It is recommended that when adjusting the picture, the horizontal total should be adjusted before the horizontal phase. However, if
the picture still flickers even after you have adjusted both, try lowering the picture noise.