Hitachi KP-FM200WCL, Operation Manual

Page: 14 / 43

6
(4) DATA BIT : Setting of output bit depth
8bit (Factory setting) : Image is outputted by 8 bit.
10bit : Image is outputted by 10 bit.
(5) CONFIG
：
Setting of Camera Link configuration
BASE （ Factory setting ） : Camera Link configuration is set to Base configuration.
MEDIUM : Camera Link configuration is set to Medium configuration.
FULL : Camera Link configuration is set to Full configuration.
(6) CLK
：
Setting of Camera Link clock frequency
80MHz
（
Factory setting
）
: Camera Link clock frequency set to 80MHz.
40MHz : Camera Link clock frequency set to 40MHz.
(7) FLIP
：
Setting of upper and lower, right and left reversing output
OFF （ Factory setting ） : Image is usually output.
H : Image is reversed right and left.
V : Image is reversed up and down.
HV : Image is reversed right and left, up and down.
(8) TEST PATTERN ： Setting of test pattern output
OFF （ Factory setting ） : Image is usually output.
H : The horizontal lamp image is output.
V : The vertical lamp image is output.
HV : The horizontal and vertical lamp image is output.
(9) OUTPUT SIGNAL ： Setting of the tenth pin of DCIN/SYNC connector
OFF （ Factory setting ） : No output （ LOW ）
FLASH : The flash pulse (strobe) is output.
VD : The VD pulse of the camera is output.
(10) GAIN ： Adjustment of digital gain
x1
～
x4 : x1 to x4 are set by 769 steps(0 to 768). (Factory setting : x1)
GAIN = 1 + Setting value×0.00390625
(11) BLACK LEVEL ： Adjustment of offset level
0/255 ～ 127/255 : Offset level is set by 128 steps. （ Factory setting : 0/255 ）
(12) PARTIAL SCAN ： Setting of partial scanning
OFF(Factory setting),
1AREA to 8AREA
: The number of areas of partial scan is set.
AREA START
（
1th to 8th
）
: Setting of starting position in scan area
（
1th to 8th
）
.
1 to 1088 : Scan is started from the line set up in 1 to 1088.
AREA WIDTH （ 1th to 8th ） :Setting of width of scan area （ 1th to 8th ） .
1 to 1088 : Scan is performed number of line set up in 1 to 1088.
(13) FACTORY SETTING
SET : Return to the factory settings.