--- 32 ---
(c) Mounting the Click Spring
[11]
and the Front Cap
[4]
.
Mount the Switch Plate
[5]
aligning with the projections of the Front Case
[12]
as shown in Fig. 4.
Mount the Click Spring
[11]
to the Front Case
[12]
.
When the Nut
[6]
is screwed in the Front case
[12]
about 1-11/12 turns (690
û
), the mark (i) of the Nut
[6]
and the marking of Switch Plate
[5]
are positioned as shown in Fig. 16. Set the narrow slit of switch flange
as shown in Fig. 16. Mount the Front Cap
[4]
aligning the narrow projection of Front Cap
[4]
with the mark
(i) of the Nut
[6]
. (The narrow projection of Front Cap
[4]
is positioned at "1" when viewed from the
outside.)
Check that the protrusion of the Click Spring
[11]
is inserted into the groove inside the Front Cap
[4]
.
Fig. 17
1
2
3
Fig. 16
(6) Reassembly of the main unit
(a) Mount the power supply unit and the drive unit that were reassembled in the above procedure to Housing
(A)
[38]
. At this time, align the protrusions of the Brush Block
[33]
, Front Case
[12]
and Motor Spacer
[30]
with the concave portions of Housing (A)
[38]
, the notch of the Magnet
[32]
with the protrusion of Housing
(A)
[38]
, and the groove of the Front Cap
[4]
with the protrusion of Housing (A)
[38]
(see Fig. 17).
