--- 30 ---
Fig. 13
(4) Reassembly of the armature unit
(a) Mounting the Motor Spacer
[30]
Mount the Motor Spacer
[30]
to the Armature and Pinion Set
[31]
. If it is too hard to mount, support the
Motor Spacer
[30]
and press down the rear end of the armature shaft of the Armature and Pinion Set
[31]
with a hand press.
(b) Mounting the Magnet
[32]
Mount the Magnet
[32]
to the Armature and Pinion Set
[31]
so that the notch of the Magnet
[32]
faces the
rear of the Armature and Pinion Set
[31]
. Hold each part securely as the Armature and Pinion Set
[31]
may be attracted to the Magnet
[32]
by the strong magnetic force (see Fig. 13).
NOTE: Be careful that the ball bearing and the washer at the rear of the Armature and Pinion Set
[31] may come off due to the magnetic force of the Magnet [32].
Pay attention to the mounting direction of the Ring Gear
[16]
, Slide Ring Gear
[23]
, Pinion (C)
[24]
and Pinion
(B)
[26]
(see Fig. 8).
Mount the Front Case
[12]
to the Rear Case
[20]
so that the concave portion of the Front Case
[12]
aligns
with the protrusion of the Rear Case
[20]
(see Fig. 15).
Fit the protrusion of Washer (B)
[29]
in the concave portion of the Rear Case
[20]
and turn it clockwise viewing
from the armature until it contacts the Rear Case
[20]
(see Fig. 12).
4
6
Fig. 12
Concave portion
Protrusion
[29]
[20]
Protrusion
Concave portion
[30]
[32]
Notch
[31]
