English
6
PRECAUTIONS ON USING ROTARY HAMMER
1.
Wear ear protections
Exposure to noise can cause hearing loss.
2.
Do not touch the bit during or immediately after
operation. The bit becomes very hot during
operation and could cause serious burns.
3.
Before starting to break, chip or drill into a wall, floor
or ceiling, thoroughly confirm that such items as
electric cables or conduits are not buried inside.
4.
Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
5.
Always hold the body handle and side handle of the
power tool firmly. Otherwise the counterforce
produced may result in inaccurate and even
dangerous operation.
6.
Wear a dust mask
Do not inhale the harmful dusts generated in drilling
or chiseling operation. The dust can endanger the
health of yourself and bystanders.
SPECIFICATIONS
Voltage (by areas)*
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
Power input
1400 W*
Capacity
Drill bit: 45 mm
Core bit: 120 mm
No load speed
300/min.
Full-load impact rate
2500/min.
Weight (without cord, side handle)
9.8 kg
•Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Case (Molded plastic) ................................................. 1
(2) Side Handle ................................................................. 1
(3) Stopper ........................................................................ 1
(4) Hammer Grease A ...................................................... 1
(5) Dust Cup ...................................................................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
䡬
Through-hole drilling (Ro Hammering)
(1) Drill bit (hexagon shank)
Overall length: 280, 400, 505 mm
External dia.: 16, 19, 22, 25, 28, 32, 38 mm
䡬
Anchor hole drilling (Ro Hammering)
Taper shank
adapter
Morse taper
(No. 1)
Morse taper
(No. 2)
A-taper
B-taper
Application drill bit
Drill bit (taper shank)
11, 12, 14.3, 14.5, 17.5 mm
Drill bit (tape shank)
21.5 mm
Taper shank adapter formed A-
taper or B-taper is provided as
optional accessory, but drill bit for
it is not provided.
(1) Center
pin
(Guide
plate)
(2) Core
bit
(3) Core bit
shank
䡬
Large dia. hole boring (Ro Hammering)
(1) Center pin
䢇
Applied to core bits from 38 mm to 120 mm
䢇
Applied to core bits 32 mm and 35 mm
NOTE
Do not use core bits 25 mm or 29 mm.
(2) Core bit
䢇
External dia. 25, 29, 32, 35, 38, 45, 54, 64, 79, 94, 105,
120 mm
(with guide plate, not applicable to cores 25 mm or
29 mm)
(3) Core bit shank
䢇
Applied to core bits above 38 mm
䢇
Applied to core bits below 35 mm
(3) Cotter
(1) Drill bit (taper shank)
External dia.: 11, 12, 14.3,
14.5, 17.5,
21.5 mm
(2) Taper shank
adapter
01Eng_DH45SA_WE_6L
6/28/07, 12:22
6
