English
11
APPLICATIONS
Rotation and hammering function
䡬
Drilling anchor holes
䡬
Drilling holes in concrete
䡬
Drilling holes in tile
Rotation only function
䡬
Drilling in steel or wood
䡬
Tightening machine screws, wood screws
REMOVAL AND INSTALLATION METHOD
OF BATTERY
1.
Battery removal
Hold the handle tightly and push the battery latch
to remove the battery (See Fig. 3).
CAUTION
Never short-circuit the battery.
2.
Battery installation
Insert the battery while observing its polarities (See
Fig. 3).
CHARGING METHOD
NOTE:
Before plugging into the receptacle, make sure the
following points.
䡬
The power source voltage is stated on the
nameplate.
䡬
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn up.
ASSEMBLY AND OPERATION
1.
Connect the charger’s power cord to a receptacle.
When the power cord is connected, the charger’s
pilot lamp will blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical cord if
damaged. Have it repaired
immediately.
2.
Insert the battery into the charger.
Firmly insert the battery into the charger until the
line is visible, as shown in Fig. 4 .
3.
Charging
When the battery is connected to the battery
charger, charging will commence and the pilot
lamp will light in red. (See Table 2)
NOTE:
If the pilot lamp flikers in red, pull out the plug
from the receptacle and check if the battery is
properly mounted.
When the battery is fully charged, the pilot lamp
will blink in red slowly. (At 1-second intervals) (See
Table 2)
Fig. 4
Fig. 3
Latch
Handle
Insert
Battery
Pull out
Push
Line
Battery
Charger
Pilot lamp
01Eng_DH18DSL_US
2/14/13, 15:17
11
