75
<RXFDQFRQ¿JXUHDQGFRQWUROWKHSURMHFWRUYLDWKHQHWZRUNXVLQJ56&
commands.
Communication Port
The following two ports are assigned for the command control.
TCP #23
TCP #9715
Command Control Settings
&RQ¿JXUHWKHIROORZLQJLWHPVIURPDZHEEURZVHUZKHQFRPPDQGFRQWUROLVXVHG
Example: If the IP address of the projector is set to 192.168.1.10:
• Command control is not available via communication port (TCP
#9716) that is used for the e-Shot transmission function.
NOTE
1) Enter
[http://192.168.1.10]
into the address bar of the web browser.
2) Enter the Administrator ID and Password and click
[Logon]
.
3) Click
[Port settings]
on the main menu.
4) Click the
[Enable]
check box to open
[Network Control Port (Port: 23)]
to use
TCP #23. Click the
[Enable]
check box for the
[Authentication]
setting when
authentication is required, otherwise clear the check box.
5) Click the
[Enable]
check box to open
[Network Control Port (Port: 9715)]
to
use TCP #9715. Click the
[Enable]
check box for the
[Authentication]
setting
when authentication is required, otherwise clear the check box.
6) Click the
[Apply]
button to save the settings.
(
25
)
4. Utilize projector – Advanced -
4.8 Command Control via the Network
