--- 3 ---
A
Left
50 (1-31/32")
Left
50 (1-31/32")
Left
50 (1-31/32")
B
Right 30 (1-3/16")
Right 30 (1-3/16")
Right 30 (1-3/16")
Maximum height
Maximum height
Maximum height
Left
90 (3-9/16")
Left
50 (1-31/32")
Left
80 (3-5/32")
D
Left
90 (3-9/16")
Left
80 (3-5/32")
Right 90 (3-9/16")
Right 90 (3-9/16")
(Optional accessory)
(Optional accessory)
(For Europe: Standard accessory)
C
E
No
HITACHI
C 10FSH
C 10FSB
HITACHI
C 10FS
C
Fixation
fence
Sub fence
Fig. 3-1
Fig. 3-2
Fixation fence
(Optional accessory)
Sub fence
Sub fence
Fixation fence
D
C
A
E
B
Left
Right
(3) High sub fence
The Models C 10FSH and C 10FSB have a high sub fence (optional accessory). Use the sub fence for miter
cutting, right bevel cutting or crown molding cutting. The sub fence supports the workpiece widely for stable
cutting.
Table 1
Unit: mm (inch)
Maker
Model
Height
of fence
(4) Legible scale
The Models C 10FSH and C 10FSB have legibly labeled angle scale and bevel scale while the current Model
C 10FS has the scale printed on the die casting.
(5) High dust collecting performance
The dust collecting performance of the Models C 10FSH and C 10FSB is remarkably higher than the current
Model C 10FS thanks to the adoption of new dust guide and gear case.
*1: This is a method to cut a workpiece by shaking the motor head.
*2: This is a method to cut a workpiece by sliding the motor head from the front.
The dust collecting performance is obtained from the following formula:
Dust collecting performance (%) =
80.6
Maker
Model
Cutting
method
HITACHI
C 10FSH
C 10FSB
Press cutting *
1
(Size of the workpiece:
85 mm x 85 mm
(3-11/32" x 3-11/32"))
Table 2
(%)
HITACHI
C 10FS
C
Slide cutting *
2
(Size of the workpiece:
30 mm x 200 mm
(1-3/16" x 7-7/8"))
91.2
44.7
40.4
56.4
90.6
Weight of sawdust accumulated in the dust bag (g)
Weight of all sawdust during cutting (g)
x 100
