--- 2 ---
Laser beam
Turn
table
Lever
Turn the
turn table.
Laser
marker
Ink line
Fence
Workpiece
(moulding, base board, etc.)
Laser line
Laser line
Fig. 1-1
Fig. 2
Fig. 1-2
Fig. 1-3
4-1. Selling Point Descriptions
(1) Laser marker (Only Model C 10FSH)
Use the laser marker for aligning with the ink line on the
workpiece.
Cutting position can be properly adjusted by aligning the
positioning ink line with the laser line. There is no need to
make a long ink line on the workpiece.
There is no need to lower the motor head to align with the
ink line because the laser marker makes a laser line on the
workpiece. In addition, cutting position can be easily
adjusted because the operator can hold the workpiece with
both hands to move.
Cutting position can be easily adjusted because the laser
line can be aligned with an optionally angled ink line.
Even the workpieces such as crown moldings and base
boards that have decorative surfaces and are difficult to be
made an ink line can be cut just by aligning the laser line
with the ink line on the fence side. The laser line is
adjusted to the width of the saw blade at the time of factory
shipment. Depending upon the user's cutting choice, the
laser line can be aligned with the left side of the cutting
width (saw blade) or the ink line on the right side. Adjust
the position of the laser line according to "8-4. Position
Adjustment of Laser Line" on page 19.
(2) Positive angle stoppers
The Models C 10FSH and C 10FSB have positive angle
stoppers in the turn table at the right and the left of the 0˚
center setting, at 15˚, 22.5˚, 30˚ (for USA, CAN: 31.6˚) and
45˚ settings.
Thanks to the positive angle stoppers, positioning can be
done more securely than the ball index method utilized in the
current Model C 10FS. In addition, a lever is provided at the
lower tip of the turn table to secure or release the positive
angle stoppers.
Adjustment of the turn table and positioning can be easily
done while holding the side handle.
