Hitachi 28HXJ15U, Instruction Manual

Page: 14 / 45

English - 13 -
For any help concerning set up and use of your TV please call the Customer Helpline: 0845 604 0105
Installing the Batteries to the Remote
1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.
Connect Power
IMPORTANT : The TV set is designed to operate on
220-240V AC, 50 Hz %'/)I!*S%N0*!<%#"3()I&";,%(99/?%
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
Antenna / Cable Connection
Connect the “aerial” or “cable TV” plug to the AERIAL
INPUT (ANT) socket located on the back of the TV.
Switching On/Off
To Switch the TV On
M/""!)*%*-!%3/?!<%)/<8%*/%*-!%KKXUKVXO%NM,%RX%>YS%
To switch on the TV from standby mode either:
Press the “ Z%.#**/",% P+ / P- or a numeric button on
the remote control.
Press the side function switch until the TV comes on
from standby.
To Switch the TV Off
Press the “ “ button on the remote control or press
the side function switch until the TV switches into
standby mode.
To power down the TV completely, unplug the
power cord from the mains socket.
Note : When the TV is switched to standby mode, the standby
LED can blink to indicate that features such as Standby
Search, Over Air Download or Timer is active. The LED can
also blink when you switch on the TV from standby mode.
First Time Installation
P-!"% *#<"!8% /"% 0/<% *-!% H<'*% *& !,% *-!% 19(";#(;!%
selection” menu appears. The message “ Welcome
please select your language! ” is displayed in all
language options listed alphabetically.
Press the “ ” or “ ” button to highlight the required
9(";#(;!,% 3<!''% OK button to select. “First Time
Installation” appears. Use “ ” or “ ” button to set the
<![#&<!8%)/#"*<:,%("8%3<!''%1 ” button to select Search
Type. Use “ ” or “ ” to set the desired search type.
N+(&9(.9!% '!(<)-% *:3!'% (<!% Q&;&*(9% ("8% ("(9/;,% 8&;&*(9%
/"9:%("8%("(9/;%/"9:S%P-!"%'!*,%3<!''%1
” to select
Teletext Language. Use “ ” or “ ” button to set the
“Teletext Language” and select “Scan Encrypted” using
“
” or “ ” button. You can set Scan Encrypted as
Yes if you want to scan coded stations.
Default PIN code can change depending on the
selected country.
If you are asked to enter a PIN code for viewing a
!"#%/3*&/",%#'!%/"!%/0%*-!%0/99/?&";%)/8!'W%V\KR,%
0000 or 1234.
Press OK button on the remote control to continue and
the following message will be displayed on the screen.