Hisense YXE-C02U, Use And Installation Instructions

Page: 9 / 20

确 定
1
2
4
5
3
3
SIMPLE OPERATION
This wire remote controller should be used with the air- conditioner,it can be used for cooling,
heating, dry and fan etc. Other functions and settings please refer to the specific operation in this
manual.
1
.
Turning ON/OFF
< to start operation>
Press the ON / OFF button , the ON lamp lights
up, the appliance will be started.
<to Stop Operation>
Press
the ON / OFF button again , the ON lamp
goes off,the appliance will be stopped.
Hold down "ON/OFF" button for more than 3
seconds,the appliance will enter completely
shutdown state.
(indoor unit stops, cannot use timer ON to start,
only manual start), the buzzer beeps 4 times.
2 .
Mode setting
Press
"
MODE” button to select mode operation under shutdown state and no timer has been set.
AUTO mode is invalid for models without AUTO mode when setting.
After received turn off command from central controller,
the remote controller will enter completely shutdown state.
6
COOLING HEATING AUTO FAN ONLY DRY
Each time MODE button is pressed, the operation mode is changed in sequence:
3 . Temperature setting
“ ”
or
“ ”
button to set desired temperature under shutdown and no timer has been set .
blinking on the LCD,indicating entering setting mode.
Each time
“ ”
button is pressed,temperature setting rises by 1
℃；
Each time
“ ”
button is pressed,temperature setting lowers by 1
℃；
Setting temperature is finished 3 seconds after setting temperature value blinking.
Press
16
℃
/18
℃
~ ~ 30
℃
32
℃
Range of temperature setting
*HEATING, COOLING,DRY
unable to set
FAN ONLY
*: 1.
Heating mode is ineffective for COOLING ONLY models.
2.Default temperature setting range is different for different types of indoor unit
.
4.
3
.
S
etting range can be changed by professional stuff , please contact installation service when needed.
When setting temperature is above setting range, will display on the LCD, setting temperature
will not rise or lower any more .
NOTE:
NOTE:
NOTE: