Installation Instructions
8
ML19E User Manual, February 2011
Digital Video Connection
Connect one end of the DVI video cable to the DVI-D input port on the rear of the
monitor� Connect the other end to the digital video output port on the host computer�
Power Connection
The HIS-ML19 is powered by 120/240 VAC, 1�2/0�6 A, 60/50 Hz�
Connect the AC power cable to the power input port on the rear of the monitor� Connect the other
end into a nearby outlet�
Install Touchscreen
Applies to touchscreen monitors only� Instructions below apply to Windows systems� Both Serial
and USB ports are present on all touchscreen monitors, but only one should be used to connect
the touchscreen interface to the monitor�
All touchscreen monitors are shipped with a CD-ROM that contains documentation and drivers for
all major operating systems� To be sure that you have the most current information, please check
the following Internet address:
http://www�HopeIndustrial�com/Touchscreen_Drivers�htm
IMPORTANT!
If you will be using a Serial connection,
connect the Serial cable first,
and then
install the touchscreen driver� If you will be using a USB connection,
install the
touchscreen driver first,
and then connect the USB cable�
Serial (RS-232) Connection
1� Connect one end of the Serial cable to the Serial input port on the rear of the monitor�
Connect the other end to the Serial port on the host computer� Tighten the captive
screws on the cable connectors to ensure adequate strain relief�
