Hirschmann MACH 4000 Series, User Manual

Page: 39 / 236

Entering the IP parameters
Basic - L3P
Release 3.1 06/07
2.5 System configuration via BOOTP
39
2.5 System configuration via
BOOTP
During startup operation via BOOTP (bootstrap protocol) the Switch receives
its configuration data according to the “BOOTP process” flowchart
(see Fig. 13) .
Note: In its state on delivery, the Switch gets its configuration data from the
BOOTP server.
V
Activate BOOTP to receive the configuration data, see “System configu-
ration via the Web-based Interface” on page 47 or see in the CLI:
V
Make the following data for the Switch available to the BOOTP server:
# /etc/bootptab for BOOTP-daemon bootpd
#
# gw -- gateways
# ha -- hardware address
# ht -- hardware type
# ip -- IP address
# sm -- subnet mask
# tc -- template
.global:\
:gw=0.0.0.0:\
:sm=255.255.240.0:
V
Change to the Priviledged EXEC mode by entering
enable
and then
press the enter key.
V
Enable BOOTP by entering
configure protocol bootp
an then press the enter key.
V
Save the configuration entered with
copy system:running-config nvram:startup-config
and then press the Enter key.
Confirm that you want to save the configuration by pressing
y
.