Hioki SS7012, Operation Manual, Page: 14 / 20

Command Message List
10
2. Measurement
RCL
Set the address for recall sourcing
This command is valid only in recall source mode.
d1 (Address: 01 to 20) [Format]
RCL d1
d1: NR1 format
[Response]
OK or CMD ERR
SCN
Set the start address for sourcing and sourcing time interval
for scan sourcing (Refer to the caution on p.11)
This command is valid only in scan source mode.
d1 (Start address for sourcing)
01 to 20
d2 (Sourcing time interval: unit; sec.)
01 to 99
[Format]
SCN d1, d2
d1: NR1 format
d2: NR1 format
[Response]
OK or CMD ERR
SCN?
Query the scan sourcing
The contents of responses are the same as the settings.
[Format]
SCN?
[Response]
d1: Address (NR1 format)
d2: Sourcing time interval
(NR1 format)
Command Description Formats
Command Description Formats
FCM
Set the measure function.
d1 (Setting of measure function: 0 to 4)
0: OFF
1: V:2.5V
2: V:25V
3: A:25mA
4: TEMP
[Format]
FCM d1
d1: NR1 format
[Response]
OK or CMD ERR
FCM?
Query the setting of measure function.
The contents of responses are the same as the settings.
[Format]
FCM?
[Response]
d1: NR1 format
RDV?
Query the measured voltage value
This command is valid only in V:2.5V or V:25V.
d1 (Measured voltage value (in V:2.5V): unit; V)
-2.8000 to 2.8000
d1 (Measured voltage value (in V:25V): unit; V)
-28.000 to 28.000
[Format]
RDV?
[Response]
d1: NR2 format or
CMD ERR: When the input is
out of the measure-
ment range.
RDC?
Query the measured current value
This command is valid only in A:25mA.
d1 (Measured current value: unit; mA)
-28.000 to 28.000
[Format]
RDC?
[Response]
d1: NR2 format or
CMD ERR: When the input is
out of the measure-
ment range.
RDT?
Query the measured temperature value
This command is valid only in TEMP.
d1 (Measured temperature value: unit; °C)
-25.0 to 80.0
[Format]
RDT?
[Response]
d1: NR2 format or
CMD ERR: When the input is
out of the measure-
ment range.
ADJ
Zero adjustment
Zero adjust the current measurement value.
This command is valid when the measurement value is
within ±100 counts in V:2.5V, V:25V or A:25mA. [Format]
ADJ
[Response]
OK or CMD ERR