33
__________________________________________________
Chapter 2 Measurement Procedure
_____________________________________________
2.6 Auto Power-Off Function
APS
2.7 Battery Low Warning
2.8 Beep Tone
When
APS
is displayed, the auto power-off
function is active.
If no key is pressed for about 10 minutes, the
unit turns itself off automatically.
Immediately before turning off, the
APS
indication flashes and a beep tone is heard for
about 30 seconds.
Pressing any key except the
POWER
key will
extend the powered state for another 10
minutes.
To disable the auto power-off function, hold
down the
HOLD
key while turning the unit on
by pressing the
POWER
key. The
APS
indication then is not shown.
While using the recording function or the output
function of the unit, auto power-off is disabled.
When this indication appears, the battery is
exhausted and correct measurement is not
assured. Replace the battery as early as
possible.
Refer to "Chapter 2
【
Battery low voltage power-
off
】
".
To disable the beep tone, hold down the
RANGE
key while turning the unit on by
pressing the
POWER
key.
Summary of Contents for CLAMP ON LEAK HiTESTER 3283
