Hioki CLAMP ON LEAK HiTESTER 3283, Instruction Manual

Page: 35 / 64

31
__________________________________________________
Chapter 2 Measurement Procedure
_____________________________________________
rms value
→
elapsed time
→
elapsed time
→
current range
(instantaneous value) (hours) (minutes)
【
Bar graph indication BAR GRAPH
】
The bar graph display can be changed. It is
also possible to display the current range,
effective (rms) value of the measured current,
and the elapsed time (hours and minutes).
1. Press the BAR GRAPH key.
2. The current range display switches to bar graph
indication.
Each push of the BAR GRAPH key cycles
through the following modes:
When the elapsed time display is activated, the
bar graph segments flash and the elapsed time
from the point when the MAX/MIN key was
pressed is displayed.
When " min " is shown in the right-hand corner
of the bar graph, each segment of the bar graph
corresponds to one minute. Every time one
minute elapses, one segment of the flashing
bar graph goes on. When all segments on the
bar graph go on, the elapsed time is 30
minutes.
When the elapsed time exceeds 30 minutes,
one segment of the flashing bar graph goes off
every time one minute elapses.