9
_____________________________________________________________________________________________
Chapter 3 Setup and Operation of the 9332 WAVE COMMUNICATOR
______________________________________________________________________________________________
3.6 Exiting WAVE COMMUNICATOR
3.7 Modem Installation
1. In the main window, select
File - Exit
.
2. If a warming message appears, click
Yes
to save the 9332 settings before
exiting,
No
to exit without saving, or
Cancel
to return to the program.
Once you exit the program, all data about the connection is lost; be sure
to save the data before exiting.
3. This terminates the program.
To use WAVE COMMUNICATOR through a modem connection requires
modem installation. For more details, refer to the documentation supplied
with your modem. If the modem is not installed correctly, the program may
not operate normally.
Flow control
For flow control between the modem and the personal computer, avoid
software flow control (XON/XOFF). Set the flow control as follows.
1. Select
Start - Settings - Control Panel - Modems.
2. In
Modems Properties
, click the modem to be used.
3. Click
Properties
.
4. In the
Connection
tab, click
Details
.
5. Select hardware (RTS/CTS). If your modem does not support hardware
flow control, do not use flow control at all.
Modem initialization
Depending on the modem used or the telephone circuit, WAVE
COMMUNICATOR may not operate properly. In this case, try setting an
appropriate modem initialization string. Use the following procedure.
1. Select
Start - Settings - Control Panel - Modems
.
2. Click the modem being used in
Modems Properties
.
3. Click
Properties
.
4. In
Connection - Advanced - Extra settings
, enter the AT command for
initializing the modem. For details of AT commands, refer to the
documentation for the modem.
Using internal telephone circuits
The modem may not be able to detect dial tone or busy tone. Set it not to
wait for dial tone.
AT command: X1 or X3
If the line is cut off while the modem is operating
If there is a modem incompatibility problem, the carrier detect may be lost.
In this case, set carrier detect to be permanently on.
AT command: &C0
The AT commands may vary from modem to modem. For details, refer to
the modem documentation.
Summary of Contents for 9332
Page 1: ...INSTRUCTION MANUAL 9332 WAVE COMMUNICATOR ...
Page 2: ......
