HIMA HIMatrix F2 DO 8 01, Manual

Page: 12 / 40

3 Product Description F2 DO 8 01
Page 12 of 40 HI 800 157 E Rev. 1.01
3.1.1.1 Reaction in the Event of a Fault
If the device detects a faulty signal on a digital output, the affected module output is set to
the safe (de-energized) state using the safety switches.
If a fault in the device occurs, all digital outputs are switched off.
In both cases, the devices activates the
FAULT
LED.
The error code allows the user to configure additional fault reactions in the user program.
3.2 Equipment, Scope of Delivery
The available variants and their part numbers are listed below:
Designation Description Part no.
F2 DO 8 01 Remote I/O with 8 relay outputs up to 250 VAC/
250 VDC, operating temperature 0…+60 °C, for
ELOP II Factory programming tool 98 2200407
F2 DO 8 01
SILworX Remote I/O with 8 relay outputs up to 250 VAC/
250 VDC, operating temperature 0…+60 °C, for
SILworX programming tool 98 2200481
Table 4: Part Numbers
3.2.1 IP Address and System ID (SRS)
A transparent label is delivered with the device to allow one to note the IP address and the
system ID (SRS for system rack slot) after a change.
IP___.___.___.___SRS____.__.__
Default value for IP address: 192.168.0.99
Default value for SRS: 60000.200.0 (SILworX)
60000.0.0 (ELOP II Factory)
The label must not be affixed such that the air vents on the enclosure are covered.
Refer to the First Steps manual of the programming tool for more information on how to
modify the IP address and the system ID.