Hilti TE 700-AVR, Original Operating Instructions

Page: 18 / 64

12 English 428076
*428076*
• Check electric tools or appliances for damage after long periods of
transport or storage.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
9.1 Troubleshooting
Trouble or fault Possible cause Action to be taken
The breaker doesn’t
start.
Electronics initialization
in progress (takes up to
4 seconds after plugging
in).
▶
Switch the power tool
off and then on again.
The electronic restart
interlock is activated
after an interruption in
the electric supply.
▶
Switch the power tool
off and then on again.
Interruption in the elec-
tric supply.
▶
Plug in another electric
tool or appliance
and check whether it
works.
The generator is in sleep
mode.
▶
Apply a load to
the generator by
connecting a second
power consumer (e.g.
worklight). Switch the
tool off and then on
again.
The tool is faulty or ser-
vicing is due.
▶
Have the product
repaired only by Hilti
Service.
No hammering ac-
tion.
The power tool is too
cold.
▶
Bring the tip of the
accessory tool into
contact with the
working surface,
switch the power
tool on and allow it
to run. If necessary,
repeat the procedure
until the hammering
mechanism begins to
operate.