Hilti TE 60-ATC, Manual

Page: 8 / 72

2 English 2134961
*2134961*
1.2.3 Symbols in the illustrations
The following symbols are used in illustrations:
These numbers refer to the corresponding illustrations found at the
beginning of these operating instructions
The numbering reflects the sequence of operations shown in the
illustrations and may deviate from the steps described in the text
Item reference numbers are used in the overview illustrations and
refer to the numbers used in the product overview section
This symbol is intended to draw special attention to certain points
when handling the product.
1.3 Product-dependent symbols
1.3.1 Symbols on the product
The following symbols are used on the product:
Drilling without hammering action
Drilling with hammering action (hammer drilling)
Chiseling
Chisel positioning
Forward / reverse
Protection class II (double-insulated)
Protective earth / ground (only TE 60-AVR)
Diameter
Rated speed under no load
Revolutions per minute
1.4 Product information
Hilti products are designed for professional use and may be operated, ser-
viced and maintained only by trained, authorized personnel. This personnel
must be informed of any particular hazards that may be encountered. The
product and its ancillary equipment may present hazards when used incor-
rectly by untrained personnel or when used not as directed.
The type designation and serial number are printed on the type identification
plate.
▶
Write down the serial number in the table below. You will be required to
state the product details when contacting Hilti Service or your local Hilti
organization to inquire about the product.
Product information → page 3