Hilti TE 60-ATC, Manual

Page: 20 / 72

14 English 2134961
*2134961*
Trouble or fault Possible cause Action to be taken
The drill bit does not
rotate.
The function selector
switch is not correctly
engaged, is set to “Chis-
eling” , or is set to
“Chisel positioning” .
▶
Move the function
selector switch to
the “Hammer drilling”
position while the
motor is not rotating.
The drill bit cannot
be released.
The chuck is not pulled
back fully.
▶
Pull the chuck back
as far as it will go and
remove the accessory
tool.
The side handle is not
fitted correctly.
▶
Release the side
handle and refit it
correctly so that the
clamping band and
side handle engage in
the recess.
Product does not
start.
Interruption in the elec-
tric supply.
▶
Plug in another electric
tool or appliance
and check whether it
works.
The electronic restart
interlock is activated
after an interruption in
the electric supply.
▶
Switch the product off
and then on again.
The supply cord or plug
is defective.
▶
Have the supply cord
or the plug checked
by a trained elec-
trical specialist and
replaced if necessary.
The detachable supply
cord is not fitted cor-
rectly.
▶
Fit the detachable
supply cord to the
power tool correctly.
Generator with sleep
mode.
▶
Apply a load to
the generator by
connecting a second
power consumer (e.g.
worklight). After this,
switch the product off
and then on again.