Hilti TE 60-ATC, Manual

Page: 16 / 72

10 English 2134961
*2134961*
5.1.3 Setting the power level (optional) 5
TE 60-ATC/AVR
After the supply cord is connected to the AC supply, the product is
always set by default to full power.
1. Press the power reduction button. The product runs at reduced power
(50 %).
▶
The reduced-power LED lights.
2. Press the power reduction button again. The product runs at full power.
▶
The reduced-power LED goes out.
5.1.4 Fitting the accessory tool 6
1. Apply a little grease to the connection end of the accessory tool.
▶
Use only genuine Hilti grease. Using the wrong grease can result in
damage to the product.
2. Push the accessory tool into the chuck as far as it will go (until it engages).
3. After fitting the accessory tool, grip it and pull it in order to check that it
is securely engaged.
▶
The product is ready for use.
5.1.5 Removing the accessory tool 6
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or
have sharp edges.
▶
Wear protective gloves when changing the accessory tool.
▶
Pull the chuck back as far as it will go and remove the accessory tool.
5.2 Types of work
CAUTION
Risk of injury Loss of control over the product.
▶
Check that the side handle is fitted correctly and tightened securely.
Check that the clamping band is engaged in the groove in the product.
Observe the safety instructions and warnings in this documentation and on
the product.
5.2.1 Drilling with hammering action (hammer drilling) 7
1. Set the function selector switch to this symbol: .
2. Set the desired power level.
3. Press the drill bit against the work surface.
4. Press the control switch.
▶
The product starts.