Hilti TE 6-CL, Original Operating Instructions

Page: 19 / 68

*2266071*
2266071 English 13
Trouble or fault Possible cause Action to be taken
No hammering ac-
tion.
The power tool is too
cold.
▶
Bring the tip of the drill
bit into contact with
the working surface,
switch the rotary
hammer on and allow
it to run. If necessary,
repeat the procedure
until the hammering
mechanism begins to
operate.
The function selector
switch is set to “Drilling
without hammering” .
▶
Set the function
selector switch to
the “Drilling with
hammering action”
(hammer drilling)
position .
The rotary hammer
doesn’t achieve full
power.
The gauge (cross sec-
tion) of the extension
cord conductors is inad-
equate.
▶
Use an extension cord
with an adequate con-
ductor cross section.
The control switch is not
fully pressed.
▶
Press the control
switch as far as it will
go.
The drill bit does not
rotate.
The function selector
switch is not engaged or
is in the “Chiseling”
or “Chisel adjust-
ment” position.
▶
Set the function selec-
tor switch to “Drilling
without hammer-
ing” or “Hammer
drilling” .
The drill bit cannot
be released.
The chuck is not pulled
back fully.
▶
Pull the chuck back
as far as it will go and
remove the tool.
The drill bit makes
no progress.
The power tool has been
set to reverse rotation.
▶
Set the power tool to
forward rotation.
11 Disposal
Most of the materials from which Hilti tools and appliances are manu-
factured can be recycled. The materials must be correctly separated before
they can be recycled. In many countries, your old tools, machines or appli-
ances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti
representative for further information.