Hilti TE 6-CL, Original Operating Instructions

Page: 18 / 68

12 English 2266071
*2266071*
The function selector switch should be set to the “Chiseling” position
when changing the chuck.
1. Pull the sleeve of the chuck up.
2. Pull the chuck off the holder.
3. Pull the sleeve of the cleaned / new chuck up.
4. Fit the chuck onto the chuck mount.
5. Rotate the chuck slightly until it engages in position.
9 Transport and storage
Transport
▶
Do not transport this product with an accessory tool installed.
▶
Make sure that the equipment is held securely throughout all transport
operations.
▶
After transporting, always check all visible parts and controls for signs of
damage and make sure that they all function correctly.
Storage
▶
Always store this product with the electric supply cable unplugged from
the electricity supply.
▶
Store this product in a dry place, where it cannot be accessed by children
or unauthorized persons.
▶
After a long period of storage, always check all visible parts and controls
for signs of damage and make sure that they all function correctly.
10 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
10.1 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
Trouble or fault Possible cause Action to be taken
Power tool does not
start.
Interruption in the elec-
tric supply.
▶
Plug in another electric
tool or appliance
and check whether it
works.