Hilti TE 50, User Manual

Page: 15 / 62

*2102963*
2102963 English 9
5.1.2 Fitting the depth gauge (optional) 4
1. Release the side handle clamping band by turning the handle grip.
2. Slide the depth gauge from the front into the 2 guide holes provided.
3. Tighten the side handle clamping band by turning the handle grip.
➥ The depth gauge is fitted. To set the drilling depth:
4. Release the screw at the depth gauge.
5. Adjust the depth gauge to the desired drilling depth.
6. Tighten the screw at the depth gauge.
5.1.3 Fitting/removing the accessory tool 5
CAUTION
Risk of injury! The accessory tool gets hot during use.
▶
Wear protective gloves when changing the accessory tool.
▶
Do not place the hot accessory tool on readily flammable materials.
1. Apply a little grease to the connection end of the accessory tool.
2. Push the accessory tool into the chuck as far as it will go (until it engages).
➥ The product is ready for use.
3. Pull the chuck back as far as it will go and remove the accessory tool.
Use only the recommended grease supplied by Hilti . Use of unsuit-
able grease may cause damage to the product.
5.2 Types of work
ATTENTION
Risk of damage by incorrect handling!
▶
Do not operate the switches for direction of rotation and/or function
selection during operation.
Observe the safety instructions and warnings in this documentation and on
the product.
5.2.1 Drilling with hammering action (hammer drilling) 6
1. Set the function selector switch to the “Hammer drilling” position .
2. Press the drill bit against the work surface.
3. Press the control switch.
➥ The product starts.
5.3 Chisel positioning 7
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶
Do not operate the tool when the selector switch is set to “Chisel
positioning”. Turn the function selector switch until it engages in the
“Chiseling” position.
Printed: 14.12.2018 | Doc-Nr: PUB / 5283567 / 000 / 03