Hilti PM 30-MG, Original Operating Instructions

Page: 19 / 340

***** Nur für internen Gebrauch ***** 07.02.2020 / 13:17:39 - H2\DOK-Sprachpaket\System\PM_30-G1\DEU\PM30-MG_POS1
*2243556*
2243556 English 13
▶
Strong magnetic fields may affect the accuracy of the tool. Magnetic objects should thus be kept away
from the measuring tool. Hilti magnetic adapters may be used.
▶
When the tool is brought into a warm environment from very cold conditions, or vice-versa, allow it to
become acclimatized before use.
2.3 Electromagnetic compatibility
Although the device complies with the strict requirements of the applicable directives, Hilti cannot entirely
rule out the possibility of interference to the device caused by powerful electromagnetic radiation, possibly
leading to incorrect operation. Check the accuracy of the device by taking measurements by other means
when working under such conditions, or if you are unsure. Likewise, Hilti cannot rule out the possibility of
interference with other devices (e.g. aircraft navigation equipment).
2.4 Laser classification for Class 2 laser products
The tool complies with Laser Class 2 in accordance with IEC / EN 60825-1: 2014 and in accordance with CFR
21 Sec. 1040 (FDA). These devices can be used without further protective measures. Nevertheless, as with
the sun, do not look directly into the light source. If you do inadvertently look into the laser beam, immediately
close your eyes and move your head clear of the laser beam. Do not aim the laser beam at persons.
2.5 Battery use and care
▶
Observe the special guidelines applicable to the transport, storage and use of Li-ion batteries.
▶
Do not expose batteries to high temperatures, direct sunlight or fire.
▶
Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C.
▶
Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service .
▶
If the battery is too hot to touch it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Contact Hilti Service .
3 Description
3.1 Product overview 1
@
Line mode button
;
Li­ion battery
=
Warning sticker
%
Receiver mode button
&
Battery state of charge indicator
(
Laser exit window
)
Selector switch for ON / OFF and lock / un-
lock pendulum
+
Knob for fine adjustment