Hilti NURON SCO 6-22, Operating Instructions Manual

Page: 23 / 84

*2264442*
2264442 English 17
▶
Prior to each use and before and after prolonged storage, check the
product and the batteries for damage.
9 Troubleshooting
If a problem occurs, always observe the charge-status and fault indicator of
the battery. See the section headed Status indicators of the Li­ion battery .
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
Trouble or fault Possible cause Action to be taken
The battery runs
down more quickly
than usual.
Battery state of health is
not optimal.
▶
Call up the battery’s
state of health.
▶
Replace the battery.
The battery doesn’t
engage with an audi-
ble click.
The retaining lug on the
battery is dirty.
▶
Clean the retaining
lug and re-insert the
battery.
LEDs of the battery
show nothing
Battery defective
▶
Contact Hilti Service.
Product or battery
gets very hot
Electrical fault
▶
Switch the product off
immediately, remove
the battery, keep it
under observation,
allow it to cool down
and contact Hilti
Service.
The motor has no
braking effect.
Battery is discharged.
▶
Change the battery
and charge the empty
battery.
Product is momentarily
overloaded.
▶
Release the on/off
switch and then press
it again.
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping
gases or liquids.
▶
DO NOT send batteries through the mail!
▶
Cover the terminals with a non-conductive material (such as electrical
tape) to prevent short circuiting.
▶
Dispose of your battery out of the reach of children.
▶
Dispose of the battery at your Hilti Store , or consult your local gov-
ernmental garbage disposal or public health and safety resources for
disposal instructions.