![background image](http://html1.mh-extra.com/html/hilti/nuron-ncr-60-d-22/nuron-ncr-60-d-22_original-operating-instructions_2135091024.webp)
20
English
2321724
*2321724*
3.4
Coated crimping head
NCR 60 DC-A22
DANGER
Electricity presents a risk of fatal accident!
Contact with electrically live lines can lead to severe physical
injury and/or death.
▶
The crimping tool is not insulated! If you use this crimping tool in the vicinity of electrically live lines, wear
personal protective equipment.
The crimping head of the NCR 120 C-22 has a PVC coating made up of two layers. The inner layer of the
PVC coating is red, the outer layer is black.
Before each use, inspect the black coating on the crimping head for indications of damage or aging.
If you find such damage, the red coating is visible and/or the crush-hazard or electric-shock hazard
symbol is no longer legible, do not use the crimping tool and contact
Hilti
Service.
3.5
Status indicators of the Liion battery
Hilti
Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's state of health.
3.5.1 Indicators for state of charge and fault messages
WARNING
Risk of injury by a falling battery!
▶
If the release button is pressed with a battery inserted in the product, subsequently check that the battery
is correctly re-engaged and secure.
Short-press the release button of the battery to get whichever of the following status indications is applicable
at the time.
State of charge and, if applicable, faults are indicated constantly as long as the connected product is
switched on.
Status
Meaning
Four (4) LEDs show constantly green
State of charge: 100 % to 71 %
Three (3) LEDs show constantly green
State of charge: 70 % to 51 %
Two (2) LEDs show constantly green
State of charge: 50 % to 26 %
One (1) LED shows constantly green
State of charge: 25 % to 10 %
One (1) LED slow-flashes green
State of charge: < 10 %
One (1) LED quick-flashes green
The Li-ion battery is completely discharged.
Recharge the battery.
If the LED again starts quick-flashing after the bat-
tery has been charged, consult
Hilti
Service.
One (1) LED quick-flashes yellow
The Li-ion battery or the product in which it is in-
serted is overloaded, too hot or too cold, or experi-
encing some other fault.
Bring the product and the battery to the recom-
mended working temperature and do not overload
the product when it is in use.
If the message persists, consult
Hilti
Service.
One (1) LED shows yellow
The Li-ion battery and the product in which it is
inserted are not compatible. Consult
Hilti
Service.
One (1) LED quick-flashes red
The Li-ion battery is locked and cannot be used.
Consult
Hilti
Service.
3.5.2 Indicators showing the battery's state of health
To check the battery's state of health, press the release button and hold it down for longer than three
seconds. The system does not detect a potential malfunction of the battery due to misuse, for example
battery dropped or pierced, external heat damage, etc.