![background image](http://html1.mh-extra.com/html/hilti/nuron-ag-4s-22-100/nuron-ag-4s-22-100_original-operating-instructions_2135659019.webp)
*2252235*
2252235
English
13
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
6.3
Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
6.4
Installing the Hilti retaining strap (optional)
When working with the product, you must comply with national regulations for working at heights.
Comply with the operating instructions of the retaining strap.
1. Position the two tabs of the retaining strap accurately on the spark guard.
2. Secure the retaining strap with the corresponding screws through the holes provided in the spark guard.
3. Insert the battery. → page 12
6.5
Fall arrest
WARNING
Risk of injury
by falling tool and/or accessory!
▶
Use only the
Hilti
tool tether recommended for your product.
▶
Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the
Hilti
retaining strap and the
Hilti
tool tether
#2261970.
▶
Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶
Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the
Hilti
retaining strap and those of the
Hilti
tool tether.
6.6
Fitting the side handle
▶
Screw the side handle into one of the threaded bushings provided.
6.7
Fitting or removing the guard
CAUTION
Risk of injury.
The accessory tool may be hot or have sharp edges.
▶
Wear protective gloves when fitting, removing or adjusting the accessory tool or other parts and when
troubleshooting.
▶
Observe the instructions for fitting the applicable guard.
6.7.1 Installing standard guard
The guard is keyed to ensure that only guards of a type suitable for use with the product can be
installed. The keyed locating lug also prevents the guard from coming into contact with the tool.
1. Open the clamping lever.
2. Fit the guard on to the arbor collar so that the keyed locating lug engages in the recess provided.
3. Turn the guard to the required position.
Summary of Contents for NURON AG 4S-22-100
