![background image](http://html1.mh-extra.com/html/hilti/gfb-6x-a22/gfb-6x-a22_original-operating-instructions_2135654025.webp)
*2241313*
2241313
English
19
5.8
Changing the file arm
1. Remove the abrasive belt. → page 18
2. Slacken the adjusting screw.
3. Remove the securing screws and lift off the file arm.
4. Hold the new file arm in position, install the securing screws and tighten them to the specified torque.
Technical data
Tightening torque, securing screws for file arm
2.7 Nm
5. Fit the abrasive belt. → page 18
6. Adjust the belt run. → page 18
5.9
Adjusting the swivel arm
1. Slacken the locking screw of the swivel arm.
2. Tilt the swivel to the desired position.
3. Tighten the locking screw.
6
Operation
6.1
Switching on
1. Press the rear section of the on/off switch.
2. Slide the on/off switch forward.
➥ The motor runs.
3. Lock the on/off switch.
6.2
Setting the speed
▶
Use the adjusting knob to set the speed.
6.2.1 Belt speed without load
Stage 1
4.3 m/s
Stage 2
4.7 m/s
Stage 3
5.5 m/s
Stage 4
6.4 m/s
Stage 5
7.8 m/s
Stage 6
9.5 m/s
6.3
Grinding
CAUTION
Risk of injury!
Touching a moving abrasive belt can lead to painful skin abrasion and cut injuries.
▶
Do not touch the moving abrasive belt.
Do not exceed the speed rating printed on the abrasive belt.
Secure the workpiece you are going to file.
1. Lift the band file clear of the work surface.
2. Switch the tool on. → page 19
➥ The power tool then runs in sustained operating mode.
3. Set the speed. → page 19
4. Bring the band file with the abrasive belt into contact with the work surface and keep it moving with a
steady back-and-forth action.
Summary of Contents for GFB 6X-A22
