27
en
10. Disposal
Most of the materials from which Hilti power actuated tools are manufactured can be recycled. The materials
must be correctly separated before they can be recycled. In many countries, Hilti has already made arrange-
ments for taking back your old powder actuated tools for recycling. Please ask your Hilti customer service
department or Hilti sales representative for further information.
Should you wish to return the power actuated tool yourself to a disposal facility for recycling, proceed as fol-
lows: Dismantle the tools as far as possible without the need for special tools.
Separate the individual parts as follows:
P
Pa
arrtt // a
as
ss
se
em
mb
blly
y
M
Ma
aiin
n m
ma
atte
erriia
all
R
Re
ec
cy
yc
clliin
ng
g
Toolbox
Plastic
Plastics recycling
Outer casing
Plastic / synthetic rubber
Plastics recycling
Screws, small parts
Steel
Scrap metal
Used cartridge strip
Plastic / steel
According to local regulations
11. Manufacturer’s warranty – DX tools
Hilti warrants that the tool supplied is free of defects in
material and workmanship. This warranty is valid so
long as the tool is operated and handled correctly, cleaned
and serviced properly and in accordance with the Hilti
Operating Instructions, and the technical system is main-
tained. This means that only original Hilti consumables,
components and spare parts, or other products of equiv-
alent quality, may be used in the tool.
This warranty provides the free-of-charge repair or
replacement of defective parts only over the entire lifes-
pan of the tool. Parts requiring repair or replacement as
a result of normal wear and tear are not covered by this
warranty.
Additional claims are excluded, unless stringent nation-
al rules prohibit such exclusion. In particular, Hilti is
not obligated for direct, indirect, incidental or conse-
quential damages, losses or expenses in connection
with, or by reason of, the use of, or inability to use the
tool for any purpose. Implied warranties of mer-
chantability or fitness for a particular purpose are
specifically excluded.
For repair or replacement, send tool or related parts
immediately upon discovery of the defect to the address
of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporaneous
comments and oral or written agreements concerning
warranties.
Confirmation of CIP testing
The Hilti DX 462 has been system and type tested. As a
result, the tool bears the PTB approval mark of square
shape showing approval number
S 808
. In this way, Hilti
guarantees compliance with the approved type.
Unacceptable/inadmissible defects, deficiencies, etc.
determined during use of the tool must be reported to
the manager responsible at the approval authority (PTB)
and to the Office of the Permanent International Com-
mission (C.I.P.).
